Canon I-sensys Fax-l120 Drivers Windows 7 on this page. Last Updated on Mon, 20 Nov 2017 When you install the ribbon feed change lever unit, join the tip of the tractor select lever and the tractor select gear holder correctly. (Refer to Figure 2-12.) 3.2.6.3 Tractor Select Lever (Upper and Lower) Assembly Disassembly This section describes how to disassemble the tractor select lever assembly, including how to remove the ribbon feed motor and tractor select sensor. Step 1: Remove the ribbon feed change lever unit. (Refer to Section 3.2.6.2.) Step 2: Remove the two CP(S-P1)(M3x6) screws, leaf springs, and washers securing the ribbon feed motor to the ribbon feed motor frame and remove the motor. Step 3: Remove the E ring (# 3) securing the upper/lower tractor select levers and remove the levers. Step 4: Remove the E ring (# 3) securing the tractor select cam and remove the cam. Step 5: Remove the CPS(P1)(M2x10) screw securing the tractor select sensor and remove the sensor.
1 Answer The printer is an Epson DFX-8500 dot matrix. It seems to be getting caught on the perforation between pages which causes the forms to wad up. Drivers & Support; Home. The new Epson DFX-8500 - Epson's top model - offers a more favorable price-performance-ratio than you might think. Service Support Tool Canon here. Epson SIDM Black.
Step 6: Using wire cutters, cut the wire band securing the ribbon feed motor and tractor select sensor cables to the ribbon feed motor frame. Tractor Select Lever Disassembly z Attach the tractor select levers to the tractor select cam as shown in Figure 3-50. (Upper and Lower) Figure 3-50. Tractor Select Lever Installation 3.2.6.4 Ribbon Jam Sensor Removal Step 1: Remove the right cover. (Refer to Section 3.2.3.2) Step 2: Disconnect the connector for the sensor from the connector junction board.
Step 3: Remove the CP(S-P1) (M3x6) screw securing the sensor to the bracket, and remove the sensor. Ribbon Jam Sensor Removal 3.2.6.5 Connector Junction and FPC Board Assembly Removal This section describes how to remove the connector junction board assembly and FPC board assembly. Step 1: Remove the left side cover. (Refer to Section 3.2.3.2) Step 2: Disconnect all the cables from the connector junction board assembly.